ProClip Device Mounting Solutions

Mounting Hardware and Stands - Proclip - Adapts The Vc80 - Vc80X Back Hole Pattern To Industry Standard Amps. Threaded For M4 Screws. Recessed For Flush Mounting

Mounting Hardware and Stands - Proclip - Articulating Arm Kit With L-Bracket

Mounting Hardware and Stands - Proclip - 43" Floor Stand With Amps Plate - Hollow 34" Section With Cable Path (0.6 In / 15mm Inner Diameter) - 10" Flex Arm 360 Degree Flexibility - 12" Base Plate

Mounting Hardware and Stands - Proclip - Universal Fastener Pack - 4 - M4 X 10 - 14 And 20 mm Low Profile 2.5 mm Hex - 4 - M4 Lock Nut - Flat Washer - Lock Washer - 1 - 2.5 Allen Wrench

Mounting Hardware and Stands - Proclip - Charging Printer Mount Kit Quick Release Power Dock 5" Mount Zebra Zq610 Zq620

Mounting Hardware and Stands - Proclip - Quick Release Dock With Suction Cup Mount 6 Inch

Mounting Hardware and Stands - Proclip - Amps Dashboard Backer Plate

Mounting Hardware and Stands - Proclip - This Mount Can Angle - Tilt - Swivel And Extend Your Holder/Device For A Better Viewing Position. This Mount Swivels 360 Degrees Horizontally And Vertically. It Extends 6.5 Inches/ 165 mm And Can Be Attached To Any Flat Surface. The Face Plate Has An Amps Hole Pattern To Accommodate Most Holders - Cradles - Mounts And Car Kits. - This Item Does Not Come With Fasteners.

Mounting Hardware and Stands - Proclip - 10" Desktop Clamp Mount

Mounting Hardware and Stands - Proclip - Hino 200/300 Angled Mount - Commercial Mounting Platform - Strong Enough To Hold A Device In The Tough Sleeve. The Mount Attaches To The Upper Center Right Of The Center Dash. Device Holder Not Included - Sold Separately. Comes With A Pre-Drilled Hole Pattern For Device Attachment. A Device Holder Can Easily Be Attached Anywhere On The Face Plate. Compatible With: Hino 200-Series 2005 - 2020 - Hino 300-Series 2005 - 2020